Filter


Reset
Show item

Three-phase

TS3 three-phase

The TS3 three-phase power thyristor controller is used to control the load or power of industrial load applications (e.g. fans, pumps, lamps, heating coils, industrial ovens). Its solid and compact design permit seamless installation and a wear-free control with a high degree of efficiency.

Application/type Power thyristors
Configuration DIP switches
Output voltage reference voltage for potentiometer: 10 V =
Output switch contact signal contact at 100% Ua, signal contact in case of fault state, changeover contacts, 2A for 230 V ~, output for ohmic and inductive loads, 10 kW (400 V ~ / 15 A), 16 kW (400 V ~ / 25 A), 23 kW (400 V ~ / 35 A), 33 kW (400 V ~ / 50 A)
Input input for potentiometer 2,5..10 kΩ, PWM input 5 V / 5..10 kHz, input for PTC according to DIN 44081, input for reset, electrical activation via setpoint signal 0..10 V = or 0..20 mA, optionally configurable
Operating range temperature (°C) 0..+50
Operating range humidity max. 95% rH non-condensing
Power supply L1, L2, L3, N: 400 V ~ 45..65 Hz, self-synchronizing
Power consumption typ. 40 W, typ. 67 W, typ. 94 W, typ. 135 W
Display 4 LEDs showing status of the device
Enclosure aluminium
Protection (IP) IP40, according to EN 60529
Connection terminal block
Mounting 4 mounting holes Ø=8 mm for mounting on galvanized mounting plates (control cabinet)
Device length (mm) 139
Device width (mm) 200
Device height (mm) 140
Catalogue table Power thyristors
Comparison list
Top